Filter
Top Products
82
www.seuservice.com
83
www.seuservice.com
The following error messages are displayed when problems are detected during unit power-up
(during initialization of the Card Reader/Writer). Perform the appropriate maintenance based on
the content of the error message displayed.
TABLE 18. 1 b
CARD R/W ERROR!
PLEASE INSERT CLEANING
CARD.
PLEASE WAIT
CAN'T EJECT
This message is displayed
at power-up when the Card
Reader/Writer is not connected
properly or when it is broken and
unresponsive.
This message is displayed when
the conditions prompting an
automatic Card Reader/Writer
cleaning are met.
This message is displayed during
network setup while the other unit
is being initialized.
This message is displayed at
power-up when, after attempting
to do so, the Card Reader/Writer
is unable to eject a card for some
reason.
This message is displayed at
power-up when the shutter cannot
be opened/closed properly.
Verify that the Card Reader/Writer is
connected properly and then restart the
unit. (See Section 24).
If broken, contact the company from
whom the unit was purchased.
Perform the Card Reader/Writer
cleaning. (See 7-2.)
This message disappears once
initialization of the other network game
unit is complete.
Remove all cards from the Card
Reader/Writer. (See 7-3.)
Verify that there are no problems with
the shutter and then restart the unit. If
this error occurs several times, contact
the company from whom the unit was
purchased.
ERROR DISPLAY CAUSE COUNTERMEASURES
The following messages are displayed when there are limits to the Card Reader/Writer
Operation Mode. The messages are displayed in the upper right of the screen during
advertisements. The message content is updated after the "SEGA LOGO" is displayed.
If the message is not one displayed intentionally by the Operation Mode, perform the
appropriate maintenance based on the content of the error message displayed.
TABLE 18. 1 c
The machine is currently unable
to issue new cards. Please see a
store attendant to have the machine
restocked with cards.
Cards may not be used at this time.
The Card Reader/Writer Dispenser
is empty (no cards).
Cards may not be used due to
the Store Closing setting being
activated.
Restock the Dispenser with cards. (See
7-1.)
If no cards are available, contact the
company from whom the unit was
purchased.
If there is a mistake in the settings, use
Test Mode to change the Store Closing
setting. (See 10-3.)
If the setting is correct, but not
operating properly, check the internal
clock settings on the game board
(Refer to the Service Manual.)
ERROR DISPLAY CAUSE COUNTERMEASURES