Filter
Top Products
80
www.seuservice.com
81
www.seuservice.com
TABLE 18. 1 a
This card cannot be used. Card
will be ejected without saving
data. Please press the Start and
Change View buttons.
Card jam. Ejecting card. Please
press the Start and Change View
buttons.
There is a problem with the card
reader/writer. Please notify a
store attendant. Please turn off
the power and start again.
The card reader/writer is not
responding. Please notify a
store attendant. Check the
card reader/writer is connected
properly, turn off the power and
start again.
SCIF Error. Please notify a
store attendant. Check that the
card reader/writer is connected
properly, turn off the power and
start again.
Card jam. Remove the card and
press the Start and Change View
buttons. If the card cannot be
removed, please notify a store
attendant.
This message is displayed when
the card in the Card Reader/
Writer is not a proper player
card at the end of the game.
This message is displayed when
various operations fail because
of dirty rollers or heads.
This message is displayed when
there is a problem with the
Card Reader/Writer and it sends
improper signals.
This message is displayed at
power-up during advertisements
when the Card Reader/Writer is
not connected properly or when
it is broken and unresponsive.
This message is displayed when
a communication error occurs
between the Card Reader/Writer
and the game board.
This message is displayed when
various operations fail because
of dirty rollers or heads.
This message is displayed when
a card jam is suspected when
there should be no card in the
Card Reader/Writer.
Press the Start button and Change View button
at the same time to eject the card and end the
game.
Press the Start button and Change View button
at the same time to eject the card and restore
the game.
If this error occurs several times, use Test
Mode to perform manual cleaning. (See 10-
3G.)
Verify there are no problems with the shutter
and that the top cover is closed and then
restart the unit. (See 7-3.)
Verify that the Card Reader/Writer is
connected properly and then restart the unit.
(See Section 24.)
Verify that the Card Reader/Writer is
connected properly and then restart the unit.
(See Section 24.)
If this error occurs several times, check
the immediate area for sources of possible
interference.
Leave the card in place and press the Start
button and Change View button to retry the
operation.
Remove the card and press the Start button
and Change View button at the same time to
restore or end the game (refer to 7-3).
If this error occurs several times, use Test
Mode to perform manual cleaning. (See 10-
3G.)
Press the Start button and Change View button
at the same time after removing the card or
correcting the problem to restore the game.
(See 7-3.)
ERROR DISPLAY CAUSE COUNTERMEASURES