Filter
Top Products
48
www.seuservice.com
49
www.seuservice.com
D. FORCE FEEDBACK
If you select FORCE FEEDBACK, the STEERING will rotate automatically
when you press the TEST Button. The STEERING will also rotate automatically
during FORCE TEST. Make sure that no one is touching the STEERING before
running these tests as contact may cause injury.
When you select "FORCE FEEDBACK", a connection test runs and the STEERING rotates.
When the connection check completes, a screen similar to the one below is displayed, and you
may adjust the STEERING resistance.
FIG. 10. 3 d FORCE FEEDBACK Screen
FORCE: Set the STEERING resistance
The smaller the value, the weaker the resistance; the larger the value, the
stronger the resistance.
(Minimum value is 0; the maximum value is 10. The default setting is 4.)
Move the cursor to UP or DOWN and press the TEST Button to change the
value.
FORCE TEST: Veries the STEERING motor is working properly
Conducted when the STEERING resistance is set at 4.
Toggle between OFF and ON by aligning to CENTER and pressing the TEST
Button.
The STEERING will rotate and stop in the center position. Pressing the
SERVICE Button moves the cursor to the next menu item and CENTER
changes to OFF. Control of the STEERING is then released.
When the RIGHT menu item is ON, the STEERING rotates to the right as far
as possible and then stops. Press the SERVICE Button again to turn it OFF
and release control of the STEERING.
When the LEFT menu item is ON, the STEERING rotates to the left as far as
possible and then stops. Press the SERVICE Button again to turn it OFF and
release control of the STEERING.
Move the cursor to EXIT and press the TEST Button to return to the Game Test Menu screen.
GAME TEST MODE
FORCE FEEDBACK
(MIN 0 : MAX 10 : DEFAULT 4)
FORCE = XX
UP
DOWN
FORCE TEST (FORCE = 4)
CENTER OFF
RIGHT OFF
LEFT OFF
-> EXIT
SELECT WITH SERVICE BUTTON
AND PRESS TEST BUTTON
CAUTION!