Filter
Top Products
62
www.seuservice.com
63
www.seuservice.com
11. CONTROL PANEL
In order to prevent an electric shock and short circuit, be sure to turn power
off before performing work by touching the interior parts of the product.
Be careful not to damage the wires. Damaged wires may cause electric
shock or short circuit or present a re risk.
Do not touch undesignated places. Touching places not designated can
cause electric shock or short circuit.
This work should be performed by the Location's Maintenance Man or
Serviceman. Performing work by non-technical personnel can cause
electric shock hazard.
Do not perform work other than those specied in this Manual in order to
prevent accidents during performing work and operation after performing
work. Performing work not specied in this Manual may require special
training for this product. If performing work other than those stated in this
manual is required for repair, contact the ofces herein stated in this manual
or where you purchased the product from and ask for repair or inquire how
to repair.
Be very careful when soldering. Handling a soldering iron carelessly may
result in a re or a burn.
Be extremely careful when heating the heat-shrinkable tube. Failure to do
so may result in a re or burns.
Exercise extreme caution when handling the internal parts of the Control
Panel. Watch out for damage, warping and loss. The loss of just one piece
may result in damage to or lead to faulty operation of the entire unit.
When securing the plastic-made parts, do not excessively fasten screws and
nuts. Failure to observe this may damage the parts and cause injury due to
fragments resulting from damage.
Be sure to perform volume's move value setting in the Volume Setting in the
Test Mode after replacing or adjusting the Volume. (See 10-3E.)
CAUTION!
STOP
IMPORTANT!
WARNING!