Filter
Top Products
64
www.seuservice.com
65
www.seuservice.com
FIG. 11. 2 b
Loosen the 2 hexagon socket screws on the Gear Holder and remove the Gear Holder.
Remove the nut securing the VR Bracket, then separate the Volume from the VR Bracket and
replace it.
Remove the connectors.
Remove the 2 screws securing the VR Bracket and remove the entire Bracket and Volume.
This procedure requires the following tools: Philips screwdriver for the M4 screws, 2 mm
hexagonal wrench, 11—12mm monkey wrench, nipper, cutter, wire stripper, soldering iron and
industrial dryer.
VR BRACKET
CONNECTOR (1)
RED 3P
PHOTO 11. 2
REPLACEMENT PROCEDURE
SCREW (2)
M4×10, w/at & spring washers