Filter
Top Products
3-4SectionWiring and Connections
21
Installation
Lower the SRM1 so that the notch on the back of the Unit catches the top of the
DIN Track. Push the Unit forward until the lock snaps into place.
Removal
Pry the lock down with a standard screwdriver and pivot the Unit upward to re-
move it.
Screwdriver
3-4 Wiring and Connections
3-4-1 General Precautions for Wiring
I/O Line Noise To avoid noise, do not run CompoBus/S transmission lines in the same duct or
conduit as power lines.
Hanging Ducts
Leave at least 300 mm between the ducts, as shown in the following diagram.
CompoBus/S
transmission
lines
Control cables and
SRM1 power lines
Power cables
300 mm min.
300 mm min.