Filter
Top Products
39
www.seuservice.com
12.
REPLACING THE FLUORESCENT LAMP, AND LAMPS
● When performing work, be sure to turn power off. Working with power on can
cause electric shock and short circuit hazards.
● The Fluorescent Lamp, when it gets hot, can cause burn. Be very careful when re-
placing the Fluorescent Lamp.
● Be sure to use lamps of the designated rating. Using lamps of undesignated rating
can cause a fire or malfunctioning.
● To perform work safely and securely, be sure to prepare a step which is in a secure
and stable condition. Performing work without using the step can cause violent fall-
ing down accidents.
● Be careful when handling the plastic made parts. Failure to observe this may cause
injury due to damage or fragments resulting from damage.
WARNING!
CAUTION!
There are 1 fluorescent lamps inside the main projection unit billboard. Use a step or stepladder for safety
when changing the 1 lamps on the top.
FLUORESCENT LAMPS INSIDE THE BILLBOARD
Turn the main switch in the main projection AC unit to OFF.
Remove the 4 screws to remove the marquee top bracket, then remove the marquee plex, allowing
replacement of the fluorescent lamp inside the billboard.
1
2
(4) Machine screws
FLUORESCENT LAMP F30T12/CW/RE
CoolWhite