Filter
Top Products
38
www.seuservice.com
11. MONITOR
11 - 1 REPLACING MONITORS
● Prior to connecting or disconnecting monitor connectors in conjunction with instal-
lation or removal of monitors, always disconnect the power connector (plug) first.
Failure to do so can cause electrical shock or breakdown.
● Work must be performed by qualified personnel with a thorough knowledge of elec-
trical systems. Work by inexperienced persons can result in electrical shock, etc.
● Proceed with work in accordance with the procedures described in this Owner's
Manual. Electrical shock may occur if these instructions are not followed.
● To ensure safety, be sure to provide sufficient space in which to work. Working in
confined areas can cause accidents and mistakes.
● Be careful not to damage wiring. Damaged wiring can cause electrical shock or
shorting.
● Do not touch components, etc. unless directed to do so. Electrical shock or shorting
can result.
After turning the AC unit power
switch to OFF, disconnect the power
plug from the outlet.
Release and open the Station Lid.
Unhook the DB15 VGA Connector
from the monitor board and the Power
connector.
Undo the 4 11/16ths Nuts from the
monitor bracket and remove the
brackets from your monitor.
Reverse these steps to put in your new
monitor.
PHOTO 11. 4 a
Release the lock.
WARNING!
1
2
3
4
5
Undo VGA and Power.
Remove (4) nuts.