Filter
Top Products
26
www.seuservice.com
7.
PRECAUTIONS TO BE HEEDED WHEN MOVING THE MACHINE
● When moving the machine, be sure to pull out the plug from the power supply.
Moving the machine with the plug as is inserted can cause the power cord to be
damaged, resulting in a fire and or electric shock.
● When moving the machine on the floor, retract the Adjusters and ensure that Cast-
ers make contact with the floor. During transportation, pay careful attention so that
Casters do not tread power cords and earth wires. Damaging the power cords can
cause an electric shock and/or short circuit.
● When lifting the cabinet, be sure to hold the catch portions or bottom part. Lifting
the cabinet by holding other portions can damage parts and installation portions due
to the empty weight of the cabinet, and cause personal injury.
● When transporting the product in places with steps, disassemble into each unit be-
fore transporting. Inclining the product in an as is assembled condition or placing
the cabinet in places with steps can damage the unit's joining portions.
● To protect surface, do not directly apply a rope to the surfaces of product. Use pro-
tective materials to the places the rope is applied to.
● Do not use a forklift to move this product. This could cause breakage of compo-
nents, and the pieces could cause injury.
● Do not push on glass or molded parts. This could cause breakage of components,
and the pieces could cause injury.
● Do not move the stations by pulling or pushing on the armrests. This could cause
breakage, and workers could suffer injury from the pieces.
FIG. 7 a Casters of the main projection unit
On level surfaces, move the machine by causing
the casters to make contact with the surface.
WARNING!
STOP
IMPORTANT!
CAUTION!
***Note: Image Differs From Actual Unit.