Filter
Top Products
1-6
INSTALL THE LINE CORD
CAUTION: CHECK POWER SUPPLY LINE VOLTAGE SELECTOR SWITCH.
Set the
110/220 VAC selector on the power supply for the correct local line voltage. Check the
selector setting before switching on the game.
10. Reinstall the rear door and close it. Lock the rear door and remove the key. If required, install the
extra padlock through the hasp. Install the screws at the top and sides of the rear door. Tighten the
screws snugly. Close and lock the cash box and coin doors.
NOTICE:
Tamper-resistant screws and a matching wrench are provided with this game
for additional security. Four tamper-resistant screws and four wrenches are located in
the spare parts bag. If desired, replace the original screws with the tamper-resistant
screws. Tighten the screws firmly with the wrench.
11. Move the game to its play location. Lower each leg leveler until the cabinet is stable and level. Adjust
the levelers as required to raise wheels and distribute weight equally on each corner. Tighten the
nuts.
12. Plug the game into a grounded (3-terminal) AC wall outlet. Switch on the game, using the on/off
switch at the top-left rear of the cabinet. The game will power up and begin self-diagnostics. If
diagnostics find no errors, the game enters its Attract Mode of operation. Unlock and open the coin
door. Locate the control switches. Press TEST MODE to enter the Menu System.
13. Select “MONITOR SETUP” at the Diagnostics Menu. Confirm proper video display operation and
adjust the monitor as necessary.
14. Select “DISK TESTS” at the Diagnostics Menu. Run all the tests in order to verify correct drive
operation.
15. Select “SWITCH TESTS” at the Diagnostics Menu. Check to be sure that all control switches work.
16. Select “DIP-SWITCH TESTS” at the Diagnostics Menu. Verify that all switches are set to optimum
positions for this game.
17. Select “SPEAKER TEST” at the Diagnostics Menu. Verify operation of audio system components.
18. Select “EXIT” at the Main Menu. The system should enter Game-Over Mode. Open the coin door and
press the SERVICE CREDITS button to allow game play. Choose a joystick and press the START
button to begin play. Listen to the audio while playing the game. Note sound irregularities (phase
problems, no low frequencies, mono audio from stereo speakers, etc.). If necessary, check the wiring
harness for internal shorts or strapped connections.