A SERVICE OF

logo

297
SGD Wireless Commands
wlan.roam.signal
12/16/13 EPL Programming Guide 14245L-003 Rev. A
wlan.roam.signal
Description This printer setting refers to specifying the wireless roam signal. For printer
support, see SGD Command Support on page 315.
Type getvar; setvar
This table identifies the commands for this format:
Note • For details on SGD command structure, see Command Structure on page 250.
Commands Details
getvar
This command instructs the printer to respond with the specified wireless
roam signal.
Format: ! U1 getvar "wlan.roam.signal"
setvar
This command instructs the printer to set the wireless roam signal.
Format: ! U1 setvar "wlan.roam.signal" "value"
Va lues: Decimal values between 1 and 75 inclusive.
Default: "50"
Example • This setvar example shows the value set to "50".
! U1 setvar "wlan.roam.signal" "50"
When the setvar value is set to "50", the getvar result is "50".