SGD Wireless Commands
wlan.ip.dhcp.cid_all
274
14245L-003 Rev. A EPL Programming Guide 12/16/13
wlan.ip.dhcp.cid_all
Description This printer setting defines the entire client identifier (DHCP option 61) if
DHCP is enabled on the wireless print server and "wlan.ip.dhcp.cid_type" is set to
"0", or "2". The MAC address is used if the type is set to "1". For printer support, see SGD
Command Support on page 315.
Type getvar; setvar
This table identifies the commands for this format:
Note • For details on SGD command structure, see Command Structure on page 250.
Commands Details
getvar
This command instructs the printer to respond with the client identifier
prefix and suffix of the wireless print server.
Format:
! U1 getvar "wlan.ip.dhcp.cid_all"
setvar
This command instructs the printer to change the client identifer prefix and
suffix of the wireless print server. The prefix gets cleared and the suffix
contains the entire client identifer.
Format:
! U1 setvar "wlan.ip.dhcp.cid_all" "value"
Va lues: A maximum length of 60 characters if the CID type is ASCII, or
120 characters if the CID type is hexadecimal.
Default Value: ""
Example • This setvar example shows the value set to "printer".
! U1 setvar "wlan.ip.dhcp.cid_all" "printer"
What the setvar value is set to is the getvar result. In this example, the getvar result is
"printer".
