SGD Wireless Commands
wlan.ip.dhcp.cid_type
278
14245L-003 Rev. A EPL Programming Guide 12/16/13
wlan.ip.dhcp.cid_type
Description This printer setting defines the type of client identifier (DHCP option 61) that
will be sent if DHCP is enabled on the wireless print server. A value of "1" means the type of
"Ethernet" and the printer’s MAC address will be used. A value of "0" or "2" means the
client identifier sent will be "wlan.ip.dhcp.cid_prefix" concatenated with
"wlan.ip.dhcp.cid_suffix". For printer support, see SGD Command Support
on page 315.
Type getvar; setvar
This table identifies the commands for this format:
Note • For details on SGD command structure, see Command Structure on page 250.
Commands Details
getvar
This command instructs the printer to respond with the client identifier
type for the wireless print server.
Format:
! U1 getvar "wlan.ip.dhcp.cid_type"
setvar
This command instructs the printer to enable "synthetic" client identifier
for the wireless print server.
Format:
! U1 setvar "wlan.ip.dhcp.cid_type" "value"
Va lues:
"0" = ASCII string
"1" = wireless radio card’s MAC address
"2" = HEX value
Default Value: "1"
Example • This setvar example shows the value set to "1".
! U1 setvar "wlan.ip.dhcp.cid_type" "1"
What the setvar value is set to is the getvar result. In this example, the getvar result is
"1".
