System Administration
Configure Management Access
The WS 2000 Network Management System runs from a standard Web browser. Any
individual on an enabled subnet or over the WAN can access the log screen by specifying
one of the IP addresses associated with the user interface. The WS 2000 Access screen
allows the administrator to restrict access from different locations. By selecting the
appropriate checkboxes, the administrator can allow or disallow specific types of access
from the WAN port or from the LAN subnets.
Choose the types of access to allow by checking the associated checkbox.
Access Port Description
Applet
HTTP
80 Allows access to the WS 2000 Management System through a
standard http web browser communication.
Applet
HTTP
443 Allows access to the WS 2000 Management System through a
https (secure) connection from a web browser.
CLI
TELNET
23 Allows administration access to the wireless switch through
TELNET. Allows the user to access the switch through the
command line interface.
SNMP 161 Allows administration access for an SNMP server.
Note: If all the checkboxes in this section are disabled, the administrator
will not be able to access the switch through the WS2000 Management
System user interface. The only access available is through a direct
serial cable connection from a PC. All commands are given using the
command line interface. If this situation occurs accidentally, you can
restore the switch’s factory settings using the command line interface.
Copyright © 2004 Symbol Technologies, Inc. All Rights Reserved 76
WS 2000 Wireless Switch: 1.0 Date of last Revision: March 2004
