Filter
Top Products
Other Hints on
Carin for Your Ran e
Oven Light Bulb
Before replacing bulb, disconnect power to oven at the main fuse or circuit breaker
panel. Be sure that the entire oven.cavityincluding the light bulb is cool before
attemptingto remove.
To replace light bulb:
1. Carefully remove the glass light lens and lens
retainer by removingthe two screwsin the light
lens retainer using a phillips screwdriver.
Note: Thelightlensisseparatefromthe lightlens-
retainer.The two pieceswill dropdown intoyour
hands at the same time. Do NOT remove the
remainingtwo screws.
2. To obtain firm grasp on bulb, wear protective
rubbergloves.Removeby turningbulbtotheleft,
Do not touch a hot even'light bulb with a damp
cloth as bulb will break, Note: If the bulb does
breakandyouwishto removeit,be certainpower
supply is disconnected and wear protective
gloves.You may contactyour authorizedJenn-
Air ServiceContractorfor service.
3. Replacebulbwitha 40 watt oven-rated appliance
bulb. Bulb with brass baseis recommendedto
preventfusingof bulbintosocket.
4. Place lightlens insideof _ightlensretainer.Hold-
ing the lightlensand lensretainerin place,insert
the two screws into the light lens retainer and
tighten. ;;
Access Door
The accessdoor is easily removed to clean under
the range if necessary. To remove door, pull door
down and lift off pivot points. To replace door, slide
door over pivot points; lift up and insert prongs into
holes in the range.
To avoid the possibility of accidentally disconnecting
any part of the ventilation system, do not use the
area behind the access door for storage.
40