3Com 1500 Video Gaming Accessories User Manual


 
I/O Module 2-5
I/O Module
The RM and PEM must have at least one IO module installed in Slot 1.
Refer to the I/O installation guide that is shipped with the I/O modules for
installation instructions.
WARNING: The I/O modules are not hot-pluggable. You must have
the power cord disconnected when installing I/O modules in the
RM or PEM.
Powering the
RAS 1500 On or Off
There is no power switch on the RAS 1500. Use the following steps to
power on or power off the modules in a RAS 1500 stack.
Powering On the
RAS 1500
To power on the RAS 1500, connect the power cord to the AC power
port of the module and plug the power cord into the AC power supply
source.
Powering Off the
RAS 1500
To power off the RAS 1500, remove the AC power cord from the AC
power port of the module.
WARNING: Remember to power off if you remove the cover of the
router module before installation. Then unplug the power cord.
Ground Strap