Packet Walk-Throughs
9-4
8000-A2-GB21-30
April 1998
The following illustration shows how data packets flow through the service
domain. In this illustration ES1 is connected to the same LAN as the Hotwire
RTU.
97-15474a
Router
155.1.2.1
155.1.3.1
NSP1
155.1.2.2
8546 DSL
Card
155.1.3.2
RTU
135.1.3.3
155.1.3.4
Unnumbered
DSL
Interface
ES1
Host/Net
1) 155.1.3.4
2) 155.1.3.4
Subnet Mask
255.255.255.255
255.255.255.255
Next-Hop Address
155.1.3.1
135.1.3.3
S/D (Source/Destination)
src (source)
dst (destination)
Partial DSL Routing Table
ES1 pings NSP1
NSP1 issues reply to ping
1234
5
6
7
1
2 3
4 5
6
7
8
When ES1 pings NSP1:
1. ES originates a packet addressed to 155.1.2.2. Because they are both on the
155.1 network, ES1 ARPs to map NSP1’s IP address into a MAC address.
2. The RTU receives the broadcast ARP request from ES1.
3. The RTU replies to the ARP request with its own MAC address (proxy ARP).
4. After ES1 receives the ARP reply, it sends the packet to the MAC address of
the RTU.
5. Upon receiving this packet, the RTU forwards it to the 8546 DSL card over its
DSL interface.
6. When the 8546 DSL card receives this packet, the 8546 DSL card consults
its routing table to determine how to route the packet. Since a source route is
defined for ES1 (route #1), the 8546 DSL card forwards the packet to the
router (151.1.3.1), which is the next hop.
7. The router then forwards the packet to NSP1.
