A SERVICE OF

logo

Open as PDF
next previous
Network Configuration Worksheets
A-16
8000-A2-GB21-30April 1998
Service Domain Configuration Worksheets
For the service domain, select the DSL card you want to configure, and then
configure the following for each of the DSL cards in the Hotwire DSLAM:
Perform this task . . .
On this screen . . . To access the screen . . .
1. Assign IP addresses to
the DSL card LAN
interface (e1a).
(See page A-17.)
(Hotwire – DSL)
IP Network
From the Hotwire – DSL
menu, select:
Configuration
→
Interfaces
→
IP Network
2. Reset the DSL card.
(See page A-19.)
(Hotwire – DSL)
Card Reset
From the Hotwire – DSL
menu, select:
Configuration
→
Card
Status
→
Card Reset
Perform the following tasks only if assigning addresses statically
3. Create default route or a
source route.
(See page A-20.)
(Hotwire – DSL)
Static Routes
From the Hotwire – DSL
menu, select:
Configuration
→
IP
Router
→
Static Routes
4. Select RTU type
(See page A-22.)
(Hotwire – DSL)
RTU
From the Hotwire – DSL
menu, select:
Configuration
→
RTU
→
Selection
5. Configure RTU
information
(See page A-24.)
(Hotwire – DSL)
RTU
From the Hotwire – DSL
menu, select:
Configuration
→
RTU
→
Configuration
6. Add or remove a static
route to the RTU
(See page A-26.)
(Hotwire – DSL)
RTU
From the Hotwire – DSL
menu, select:
Configuration
→
RTU
→
Static Routes
Perform the following task only if assigning addresses dynamically
7. Define DHCP relay
features to enable
dynamic IP address
configuration.
(See page A-28.)
(Hotwire – DSL)
DHCP Relay
From the Hotwire – DSL
menu, select:
Configuration
→
DHCP
Relay
Use the worksheets in the following sections to record your network configuration
settings. Photocopy the worksheets as needed.