SNMP Configuration Worksheets
C-3
8000-A2-GB21-30
April 1998
SNMP Communities/Traps
Prompt Your Configuration Setting
1. Determine whether you want to enable
or disable Authentication Failure traps:
– Enter enable at the
Enable/Disable: prompt to
forward authentication failure traps
to all SNMP NMS managers
assigned to a community name.
– Enter disable at the
Enable/Disable: prompt to
prevent the forwarding of
authentication failure traps to all
SNMP NMS managers assigned to
a community name.
Authentication Failure Trap =
2. Change the default community names
at the Community Name: prompt if
desired. Hotwire DSLAM provides the
following default community names:
– public (RO – Read Only)
– mcc (RW – Read Write)
– nms (RW – Read Write)
– nms - 2 (RO – Read Only)
You can also change the access
permission for these communities. At
the ReadOnly (ro)/ReadWrite
(rw)/NoAccess (na): prompt,
specify the desired permission for each
community.
NOTE: Make sure the SNMP NMS
manager knows the correct community
name. It will need the correct
permission to access/browse the
Hotwire DSLAM.
Record the Community Names (default or
new names) and their access permissions.
public or ____________________
Access permission =
mcc or ____________________
Access permission =
nms or ____________________
Access permission =
nms – 2 or ____________________
Access permission =
