SNMP Configuration Worksheets
C-5
8000-A2-GB21-30
April 1998
Preventing Unauthorized Access
Use the SNMP Security screen to enable SNMP security (i.e., prevent
unauthorized managers from browsing or configuring the Hotwire DSLAM
network).
H If address security is to be activated, it should be activated on the MCC and
all DSL cards.
H If the NSP wants to allow an ISP or customer access to a limited set of DSL
cards, that NMS’s IP address should only be entered on those DSL cards in
the limited set.
Access the . . .
By . . .
SNMP Security screen
Selecting
Configuration
→
SNMP
→
Security
(A-F-A) from the Hotwire – MCC menu if
configuring the MCC card.
Selecting
Configuration
→
SNMP
→
Security
(A-F-A) from the Hotwire – DSL menu if
configuring a DSL card.
NOTE:
The following screen is the SNMP Security screen from the Hotwire – DSL
menu. The SNMP Security screen from the Hotwire – MCC menu is not
shown. Note, however, the Hotwire – MCC SNMP Security screen does not
show the bottom half of the screen (i.e., the RTU security section).
