IP Routing Features
Configuring OSPF
Field
State
Auth-type
Chain
Cost
Priority
Content
The current state of the interface. The value will be one of the
following:
• DOWN - the underlying VLAN is down
• WAIT - the underlying VLAN is up, but we are waiting to hear hellos
from other routers on this interface before we run designated
router election
• DR - this switch is the designated router for this interface
• BDR - this switch is the backup designated router for this interface
• DROTHER - this router is not the designated router or backup
designated router for this interface
none or simple - will be none if no authentication key is config-
ured, simple if an authentication key is configured. All routers
running OSPF on the same link must be using the same authen-
tication type and key.
The name of the key chain configured for the specified
interface. (Refer to the chapter titled “Key Management
System” in the Access Security Guide for your routing switch.
The OSPF's metric for this interface.
This routing switch's priority on this interface for use in the
designated router election algorithm.
The < ip-addr > parameter displays the OSPF interface information for the
specified IP address.
The < vlan-id > parameter displays the OSPF interface information for the
specified IP address.
5-103
