IP Routing Features
Configuring OSPF
ProCurve# show ip ospf external-link-state advertise
OSPF External LSAs
Advertisements
------------------------------------------------------------------------
000302050a0307000a00082580000005d99f0024ffffff008000000a0000000000000000
000302050a0308000a00082580000005cea90024ffffff008000000a0000000000000000
000302050a0309000a00082580000005c3b30024ffffff008000000a0000000000000000
000302050a030a000a00082580000005b8bd0024ffffff008000000a0000000000000000
000002050a0321000a000824800009cdb9dd0024ffffff00800000010000000000000000
Figure 5-40. Example of the Output for Show IP OSPF External-Link-State Advertise
Displaying OSPF Interface Information
To display OSPF interface information, enter show ip ospf interface at any CLI
level:
ProCurve# show ip ospf interface
OSPF Interface Status
IP Address Status Area ID State Auth-type Cost Priority
--------------- -------- --------------- ------- --------- ------ ---------
10.3.18.36 enabled 10.3.16.0 BDR none 1 1
10.3.53.36 enabled 10.3.48.0 BDR none 1 1
Figure 5-41. Example of the Output for Show IP OSPF Interface
Syntax: show ip ospf interface [vlan < vlan-id > | < ip-addr >]
The OSPF interface display shows the following information:
Table 5-12. CLI Display of OSPF Interface Information
Field
IP Address
Status
Area ID
Content
The local IP address for this interface.
enabled or disabled - whether OSPF is currently enabled on
this interface.
The ID of the area that this interface is in.
5-102
