IP Routing Features
Configuring OSPF
For example, if you wanted to monitor the neighbor-state-change and inter-
face-receive-bad-packet traps, you would use the following commands to
configure the routing switch to enable the desired trap. The show command
verifies the resulting OSPF trap configuration.
ProCurve(ospf)# trap neighbor-state-change
ProCurve(ospf)# trap interface-receive-bad-packet
ProCurve(ospf)# show ip ospf traps
OSPF Traps Enabled
==================
Neighbor State Change
Interface Receive Bad Packet
Figure 5-32. Example of Enabling OSPF Traps
11. Optional: Adjust Performance by Changing the VLAN
or Subnet Interface Settings
The following OSPF interface parameters are automatically set to their default
values. No change to the defaults is usually required unless needed for specific
network configurations.
Parameter Default Page
cost 1
dead-interval 40 seconds
hello-interval 10 seconds
priority 1
retransmit-interval 5 seconds
transit-delay 1 second
A setting described in this section can be configured with the same value
across all subnets in a VLAN or be configured on a per-interface basis with
different values.
Note Most of the parameters in this section also apply to virtual link configurations.
However, when used on a virtual link configuration, the OSPF context require-
ment is different and the parameters are applied only to the interfaces
included in the virtual link. Refer to “Optional: Adjust Virtual Link Perfor-
mance by Changing the Interface Settings” on page 5-90.
5-81
