Filter
Top Products
TL-WA7210N
2.4GHz 150Mbps Outdoor Wireless Access Point User Guide
41
1. Wired
This field displays the current settings or information for the LAN, including the MAC address, IP
address and Subnet Mask.
2. Wireless
This field displays basic information or status for wireless function, including Operation Mode,
Name (SSID), Channel, Mode, Channel Width and MAC address.
3. WAN
These parameters apply to the WAN port of the router, including MAC address, IP address,
Subnet Mask, Default Gateway and DNS server. If PPPoE is chosen as the WAN connection
type, the Disconnect button will be shown here while you are accessing the Internet. You can
also cut the connection by clicking the button. If you have not connected to the Internet, just click
Connect to establish the connection.
4. Traffic Statistics
This field displays the router's traffic statistics.
5. System Up Time
The total up time of the router since it was powered on or reset.
4.3 Quick Setup
Please refer to Section 3.2: "Quick Setup".
4.4 Operation Mode
Selecting Operation Mode will allow you to choose the operation mode for the AP. The AP
supports seven operation mode types, AP Client Router, AP Router, Access Point, Multi-SSID,
Repeater (Range Extender), Bridge with AP and Client. Please select the one your want as
shown in Figure 4-2
. Click Save to save your choice.
Figure 4-2 Operation Mode
AP Client Router - In this mode, the device enables multi-users to share Internet from WISP.
The LAN port devices share the same IP from WISP through Wireless port. While connecting
to WISP, the Wireless port works as a WAN port at AP Client Router mode. The Ethernet
port acts as a LAN port.