Filter
Top Products
TL-WA7210N
2.4GHz 150Mbps Outdoor Wireless Access Point User Guide
5
1.4.2 The Rear Panel
Figure 1-2 Rear Panel sketch
View from left to right, the parts are explained below.
: This is where you can connect an outside antenna. For this AP, the antenna is built inside,
and usually there is not necessary to connect an outside one.
LAN: This port is used to connect to the POE port of the provided Power Injector.
RESET:
There are two ways to reset the AP's factory defaults:
• Use the Factory Defaults function on System Tools -> Factory Defaults page in the
AP's Web-based Utility.
• Use the Factory Default Reset button: Press and hold the RESET button for at least 5
seconds, and then the AP reboots after the LED at the rightmost in Figure 1-1 flashes.
Note:
Ensure the AP is powered on before it restarts completely.