Filter
Top Products
Technical Bulletin
SoundPoint
®
IP, SIP 2.1
4
The following guidelines should be noted:
• You must use only *, #, or 0-9 between second and third R
• If a digit map does not comply, it is not included in the digit plan as a valid
one. That is, no matching is done against it.
• There is no limitation on the number of R triplet sets in a digit map.
However, a digitmap that contains less than full number of triplet sets (for
example, a total of 2Rs or 5Rs) is considered an invalid digit map.
• Using T in the left part of RRR syntax is not recommended. For example,
R0TR322R should be avoided.
This configuration attribute is defined as follows:
Dial Plan in Per-Phone Configuration File
Per-registration dial plan configuration is supported.
The
<dialplan/>
attribute is described below and also includes:
• Digit Map <digitmap/> on page 3.
Attribute Permitted Values Default Interpretation
dialplan.digitmap string compatible with
the digit map feature of
MGCP described in
2.1.5 of RFC 3435.
String is limited to 768
characters and 30
segments; a comma is
also allowed; when
reached in the digit
map, a comma will
turn dial tone back
on;’+’ is allowed as a
valid digit; extension
letter ‘R’ is used as
defined above.
[2-9]11|0T|
+011xxx.T|
0[2-9]xxxxxxxxx|
+1[2-9]xxxxxxxx|
[2-9]xxxxxxxxx|
[2-9]xxxT
When this attribute is present,
number-only dialing during the
setup phase of new calls will be
compared against the patterns
therein and if a match is found, the
call will be initiated automatically
eliminating the need to press Send.
Attributes
dialplan.applyToCallListDial
,
dialplan.applyToDirectoryDial
,
dialplan.applyToUserDial
, and
dialplan.applyToUserSend
control the use of match and
replace in the dialed number in the
different scenarios. Refer to page 2.
dialplan.digitmap.timeOut string of positive
integers separated by
‘|’
3 | 3 | 3 | 3 | 3 | 3 | 3 Timeout in seconds for each
segment of digitmap.
Note: If there are more digit maps
than timeout values, the default
value of 3 will be used. If there are
more timeout values than digit
maps, the extra timeout values are
ignored.