Filter
Top Products
Technical Bulletin
SoundPoint
®
IP, SIP 2.1
2
Dial Plan in Application Configuration File
The
<dialplan/>
attribute is described below and also includes:
• Digit Map <digitmap/> on page 3.
This configuration attribute is defined as follows:
Local Web Server
(if enabled)
Specify impossible match behavior, trailing # behavior,
digit map matching strings, and time out value.
Navigate to: http://<phoneIPAddress>/appConf.htm#ls
Changes are saved to local flash and backed up to
<Ethernet address>-phone.cfg on the boot server.
Changes will permanently override global settings unless
deleted through the Reset Local Config menu selection.
Note
The dial plan is not applied against Placed Call List, VoiceMail, last call return, and
remote control dialed numbers.
Attribute
Permitted
Values
Default Interpretation
dialplan.applyToCallListDial 0, 1 0 This attribute covers dialing from
Received Call List and Missed Call List
including dialing from Edit or Info sub-
menus.
If set to 0, the dial plan is not applied
against the dialed number.
if set to 1, the dial plan is applied
against the dialed number.
dialplan.applyToDirectoryDial 0, 1 0 This attribute covers dialing from
Directory as well as Speed Dial List.
Value interpretation is the same as for
dialplan.applyToCallListDial
.
Note: An Auto Call Contact number is
considered a dial from directory.
dialplan.applyToUserDial 0, 1 1 This attribute covers the case when the
user presses the Dial soft key to send
dialed number when in idle state
display.
Value interpretation is the same as for
dialplan.applyToCallListDial.