Filter
Top Products
Section 6 – System Software CDs
gvrSX™ Conversion System Manual
Page 38 of 48 040-0050-01 Rev. A 10/29/2004
Section 6 – System Software CDs
If the software running on your gvrSX™ computer develops problems, you can restore the
software using the disks provided with your kit. The Windows XP System Disk will load the
Operating System. Each Game CD will load one game. Please be aware, when you use the
System Disk, you will erase all history for the coin and game audits stored in the software.
Operating System Restore CD
1. System restore takes about 10 minutes. Power ON the computer and open the CD
drive. Insert the CD labeled System Disk and reboot the computer. When the computer
reboots, the CD will run, and you will see the hard-drive image process screens.
2. When the hard-drive image process has finished, and the image process screen
disappears, remove the CD and reboot the computer.
3. When the computer reboots it will continue processing files. When a prompt asks if you
want to restart your computer, reboot to complete the process.
Game Software CDs
To install a game without restoring the operating system, insert the Game CD while the game
is running in attract mode. Do not perform a Game Install or Upgrade while a game is
playing. Game installation takes less than 5 minutes per game.
1. When the computer reboots after restoring the operating system, you will see a blank
desktop screen. Insert one of the Game CDs in the drive. The CD will automatically run
(wait about 60 seconds). You will see a series of processing screens as the computer
installs various components. Ignore any onscreen messages.
2. When the computer finishes copying files, the system will automatically reboot. Once
the game has restarted and the attract screen is running, remove the CD and keep it in a
safe place.
3. When the game loads up for the first time, synchronize the new game software with the
cabinet hardware. To do this, insert three credits and verify that the credits are shown on
the monitor. Finally, power the system OFF and ON to complete the synchronization
process.
4. Repeat steps 1 through 3 to install more game titles. Insert the game CD during attract
mode and the install process will begin automatically.
5. After all game titles are installed, run the Joystick Calibration Utility (see page 26).