Filter
Top Products
Section 2 – Cabinet Conversion
gvrSX™ Conversion System Manual
Page 14 of 48 040-0050-01 Rev. A 10/29/2004
3. Install the exhaust fan behind the ventilation slot, just above the rear cabinet door, as
shown by the arrow in the picture below.
4. Place the exhaust fan on the outside of the ventilation slots and use the mounting holes in
the fan as a template to drill the mounting holes. Use an 11/64" drill bit to drill the four
mounting holes for the exhaust fan.
5. Place the fan on the inside of the cabinet so that it will blow air out of the cabinet. Use
the 8-32 x 2 inch screws with nuts to secure the fan to the cabinet, as shown in the picture
above.
6. Plug the fan into the AC power strip inside the cabinet, and verify that the fan blows air
out of the cabinet.