Filter
Top Products
Section 2 – Cabinet Conversion
gvrSX™ Conversion System Manual
Page 20 of 48 040-0050-01 Rev. A 10/29/2004
Connect the Computer
Refer to Figure 7, Computer Rear Panel Diagram, on page 45, and Figure 5, Simplified
Wiring Diagram, on page 44 to make the connections to the computer.
1. Connect the USB hub to one of the computer USB ports and install the game dongles in
the USB hub. Refer to the section titled USB Game Dongles on page 37 for more
information on the dongles and USB hub.
2. Connect the audio cable from the green audio port of the computer to J2 of the Jamma
Conversion Board.
3. Connect the video cable from the computer VGA port to J1 of the UVC (if used) or the
monitor.
4. Connect the USB cable from the computer USB port to the UGCI board.
Important: The USB connector from the UGCI board must be connected directly to the
USB port on the computer, not to the USB hub.
5. Secure the wires to the cabinet so they do not get pinched or torn if the cabinet has a
sliding control panel.
6. Connect the power cord from the computer to the AC power strip.