Filter
Top Products
Section 2 – Cabinet Conversion
© 2004 GLOBAL VR
®
, INC.
040-0050-01 Rev. A 10/29/2004 Page 23 of 48
4. Place the joystick direction sticker over the joystick hole. Make sure that it is properly
aligned with the cabinet and monitor and then peel off the backing and apply the sticker.
If the sticker has protective paper over the face, wet the paper and wait about 15 minutes
before removing it to avoid damaging the artwork.
5. Center the button function stickers about 3/4-inch below the button holes as shown in the
picture that follows. The Missiles buttons are outboard and the cannon buttons are
inboard. Once the graphics are lined up properly, peel off the backing and apply each
sticker.
6. Once all of the control panel graphics have been applied, re-install the clear plastic
control panel cover and secure it with the nuts and bolts removed previously.
Install Buttons and Connect Wiring
1. Install the buttons on the control panel.
2. If your cabinet has an extra button hole that is not used by the gvrSX™ system, install the
button plug from the kit to cover the unused button hole.
3. Re-install the joystick handle.
4. Connect the joystick harness to the joystick.
5. Refer to the labels on each wire of the button harness and connect the wires to the correct
buttons. Note that the trigger button wires connect to the joystick.
6. Use wire ties to secure the wires so that they won’t get pulled or pinched when the
control panel and service tray are opened or closed, as shown in the figure below.