snmp-server enable traps hg-lbm
Enable the generation of SNMP traps and notifications when HiGig link-bundle monitoring is enabled.
Z9500
Syntax
snmp-server enable traps hg-lbm
Parameters
hg-lbm Enter the keyword hg-lbm to enable traps for HiGig link-
bundle monitoring.
Command
Modes
CONFIGURATION mode
Command
History
Version Description
9.2.1.0 Introduced on the Z9500 switch.
9.3.0.0 Introduced on the Z9000 platform.
UDP Broadcast
The user datagram protocol (UDP) broadcast feature is a software-based method to forward low
throughput (not to exceed 200 pps) IP/UDP broadcast traffic arriving on a physical or VLAN interface.
Important Points to Remember
• Routing information protocol (RIP) is not supported with the UDP Broadcast feature.
• If you configure this feature on an interface using the ip udp-helper udp-port command, the ip
directed-broadcast command becomes ineffective on that interface.
• The existing show interface command has been modified to display the configured broadcast
address.
debug ip udp-helper
Enable UDP debug and display the debug information on a console.
Z9500
Syntax
debug ip udp-helper
To disable debug information, use the no debug ip udp-helper command.
Defaults Debug disabled.
Interfaces
911
