ttl_value IP TTL value of the ERSPAN traffic. The range is from 1 to
255. The default value is 255.
drop Monitors only the dropped packets in the Ingress.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Added the drop parameter.
9.7(0.0) Introduced on the S6000-ON. Introduced the set ip
dscp and set ip ttl parameters.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
9.0.2.0 Introduced on the S6000.
9.0.2.0 Introduced on the MXL.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage
Information
The monitor command is saved in the running configuration at Monitor Session
mode level and can be restored after a chassis reload.
Example
Dell#show monitor session
SessID Source Destination Dir Mode Source
IP Dest IP DSCP TTL
------ ------ ----------- --- ----
--------- -------- ---- ---
0 Te 1/12 remote-ip rx Flow
1.1.1.1 7.1.1.2 0 255
0 Po 1 remote-ip tx Flow
1.1.1.1 7.1.1.2 0 255
1 Vl 11 remote-ip rx Flow
5.1.1.1 3.1.1.2 0 255
Related
Command
show monitor session — displays the monitor session.
show running-config monitor session — displays the running configuration of a
monitor session.
1438
Port Monitoring
