destination Enter the IP address of the network or host to which the
packets are sent.
operator (OPTIONAL) For TCP and UDP parameters only. Enter one of
the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two
ports for theport command parameter.)
Defaults none
Command
Modes
REDIRECT-LIST
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added the keyword track-id on the Z9500.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1 Introduced on the C-Series.
8.4.2.0 Introduced on the E-Series TeraScale.
seq
Configure a filter with an assigned sequence number for the redirect list.
Z9500
Syntax
seq sequence-number {permit | redirect {ip-address | tunnel
tunnel-id}[track <obj-id>] }} {ip-protocol-number | protocol-
type} {source mask | any | host ip-address} {destination mask |
any | host ip-address} [bit] [operator]{source-port source-
port| source-port-range start-port - end-port} {destination-
port destination-port| destination-port-range start-port - end-
port}
Policy-based Routing (PBR)
1429
