• Level the scale by adjusting the four feet. The scale should be
adjusted such that the bubble in the spirit level is in the centre of
the level and the scale is supported by all four feet.
• Attach the power supply cable to the connector on the right side
of the scale base. Plug in the power supply module. The power
switch is located at the right side of the scale base.
• The scale will show the model number in the “Weight” display
window (CBDa 15- where 15 denotes the maximum capacity of
the scale in Kg) and the current hardware and software revision
numbers in the “Unit Weight” display window .
(For example “1.4-1 .11”: The first number “1.4” is the hardware
revision number of the main circuit board and the next one “1 .11”
is the software revision number).
• Next a self-test is followed. At the end of the self-test, it will
display “0” in all three displays, if the zero condition has been
achieved.
SETTING UP THE REMOTE SCALE
• The CBDa Series can be connected to any size of load cell type
weighing base via the Remote scale port on the right side of the
scale case. Ensure you have the correct base for the scale as
each is matched for calibration.
• Place the remote scale platform in the position where it is to be
used. Level the scale by adjusting the four feet. If fitted with a
spirit level then it should be adjusted such that the bubble is in
the centre.
• Press [Local/Rem] and test weighing performance.
© Adam Equipment Company 2007
6
