5.2 UNIT WEIGHT WINDOW
• This display will show the unit weight of a sample. This value is
either entered by the user manually or computed by the scale.
The unit of measure is either gram on all scales with kilogram
selected as weighing unit or in pounds.
• When the scale has determined that there is insufficient number
of samples to accurately determine the count, an arrow will be
shown above "Smpl".
• When the unit weight is not large enough to determine an
accurate count, the arrow will show at "U.Wt".
• When a value has been entered into the memory, the arrow
above "M+" will be on.
• In both the cases the scale continues to operate and the
indicators are to alert the user of a potential problem.
5.3 COUNT WINDOW
• This display will show the number of items on the scale or the
value of the accumulated count. See the OPERATION section.
• An arrow above the symbols will indicate the following:
Checkweighing is active during counting, "Ck Pcs"
Checkweighing is active during weighing, “Ck Wt”
Checkweighing is active, result is above the High Limit, “High”
Checkweighing is active, result is between the Low and High
Limit, “OK”
Checkweighing is active, result is below the High Limit, “Low”
• Just under the “Count” display is an LED to indicate the status
of the battery charging. When the scale is plugged into the
main power the internal battery will be charged. If the LED is
green, the battery has a full charge. If it is red, the battery
requires further charging and yellow indicates the battery is
being charged.
© Adam Equipment Company 2007
10
