6.2 MEMORY FUNCTIONS
The [M+] key will add the results of a weighing into memory, regardless of
whether the local or remote scale is being used for the weighing.
6.2.1 Manual accumulation
• The values (weight and count) shown on the display can be
added to the values in the accumulator by pressing the [M+]
key. The "Weight" display will show the total weight, the
"Count" display will show the total accumulated count and the
"Unit Weight" display shows the number of times items have
been added to the accumulation memory. The values will be
displayed for 2 seconds before returning to normal.
• The scale must return to zero or a negative number before
another sample can be added to the memory.
• More products can then be added and the [M+] key pressed
again. This can continue for up to 99 entries or until the capacity
of the “Weight” display is exceeded.
• To observe the total value stored, press the [M+] key when the
scale is at zero. The total will be displayed for 2 seconds.
• To clear the memory, first press [M+] to recall the total from the
memory and then press [CE] to clear all values from the
memory.
6.2.2 Automatic accumulated total
• The scale can be set to automatically accumulate total when a
weight is placed on the scale. This eliminates the need to press
the [M+] key to store values into the memory. However the
[M+] key is still active and can be pressed to store the values
immediately. In this case, the values will not be stored when
the scale returns to zero.
• See PARAMETERS Section on enabling Automatic
Accumulation.
© Adam Equipment Company 2007
14
