6.4.3 RECALLING PLU’S MANUALLY
• To recall the PLU values the user should first select either local or
remote scale as the tare value stored will be specific to the scale
selected.
• Then press the [PLU] key, enter the PLU number (00 – 99) then
press the [PLU] key again to recall the data.
• The display will show the results of the recall for 1 second then return
to weighing with the data in place.
For example:
ACTIONS DISPLAYS
Press [PLU]
“PLU ”
“ - -“ “ “
Press [2], [7]
“PLU ” “ 27” “ “
Press [PLU]
“PLU 27 ” “M 4 Nut“ “Brass “
After 1 second, it will return to
normal weighing with the Tare and
Unit Weight previously entered.
“ x x x x“ “ x x x x ” “ x x“
• If the [PLU] key is held down after the numeric entry, it will show the
description as long as the key is pressed.
• In this example the display “PLU 27 ” “M 4 Nut“ “Brass “ shows the
description for 1 second, if no data is stored then it will show
“PLU 27” “ “ “ “.
• To display the current PLU, press the [PLU] key in the
Counting/Weighing mode. Press [CE] to return to normal weighing.
• If the tare value is outside the range permitted for the selected scale
(For example, if the local scale is selected whereas the tare value
applies to the remote scale, this would exceed the capacity of the
local scale) the “Weight” display would show zero tare weight.
© Adam Equipment Company 2007
21
