12.0 TECHNICAL PARAMETERS
The technical parameters accessed via the “tEch” prompt at the end of user
parameters and are password controlled to prevent unauthorised access.
These parameters set the metrology for the scales. Each scale is set
independently. The parameters will set capacity, division, decimal point
position, initial zero range, auto and manual zero range as well as factory
calibration.
ACTION DISPLAYS
When “tEch” is displayed, Press the
[Print] key. The scale will ask you
to enter the password.
“ Pi n”
Default Password is 0000.
Enter “0” four times.
9999 will override any other user
password. Press [Print].
“ Pi n” “ ----”
Select the scale to be set up by
using the [Local/Rem] key.
Press the [Print] to enter the
technical section for that scale.
“t Ech” “ Lo c A L” “ “
“t Ech” “r E mo t E” “ “
Use the [U.Wt./Units] to select the
weighing unit to be used for setting
up the parameters for the scale.
The arrow in the “Weight” window
will indicate the unit selected.
Press the [Print] key to continue.
“t Ech” “ Uni t” “ “
Press the [U.Wt./Units] key to
scroll through the menus for the
chosen scale. User [Print] to
select and set parameters and the
[Tare/Zero] to escape as without
changing data as with the user
parameter section.
“Cn t”
Both scales have the same menus
except that the capacity of the local
scale is fixed and cannot be
entered.
© Adam Equipment Company 2007
30
