VDSL Commands
4-119
Command Mode
Privileged EXEC
Example
show controllers efm channel-table
This command displays channel interface information for the selected VDSL port.
For details see “Displaying VDSL Interface Information” on page 3-66.
Syntax
show controllers efm channel-table {vtu-r | vtu-c} [interface]
• vtu-r – VTU (VDSL Transceiver Unit) at the remote end of the line
• vtu-c – VTU (VDSL Transceiver Unit) at the near (central) end of the line
• interface – Ethernet interface to display
• unit/port
- unit - This is device 1
- port - Port number
Command Mode
Privileged EXEC
Example
Console#show controllers efm phy-table vtu-c 1/1
VDSL_PHYS_ENTRY :
Ethernet 1/1 Serial Number
Ethernet 1/1 Vendor ID ACCTON
Ethernet 1/1 Version Number 91
Ethernet 1/1 Current Signal to Noise Ratio Margin 45
Ethernet 1/1 Current Attenuation 54
Ethernet 1/1 Current Status 0
Ethernet 1/1 Current Output Power -12
Ethernet 1/1 Current Attainable Rate 1350000
Ethernet 1/1 Current Line Rate 1350000
Console#
Console#show controllers efm channel-table vtu-c 1/1
VDSL_CHAN_ENTRY :
Ethernet 1/1 Channel Interleave Delay 0
Ethernet 1/1 Channel CRC Block Length 0
Ethernet 1/1 Channel Current Transmit Rate 0
Ethernet 1/1 Channel Current Transmit Slow Burst Protect 0
Ethernet 1/1 Channel Current Transmit Fast Forward Error Correction 0
Console#
