Command Line Interface
4-4
Showing Commands
If you enter a “?” at the command prompt, the system will display the first level of
keywords for the current command class (Normal Exec or Privileged Exec) or
configuration class (Global, ACL, Interface, Line, VLAN Database, or MSTP). You
can also display a list of valid keywords for a specific command. For example, the
command “show ?” displays a list of possible show commands:
The command “show interfaces ?” will display the following information:
Partial Keyword Lookup
If you terminate a partial keyword with a question mark, alternatives that match the
initial letters are provided. (Remember not to leave a space between the command
and question mark.) For example “s?” shows all the keywords starting with “s.”
Console#show ?
bridge-ext Bridge extend information
calendar Date information
controllers Interface controller status
dot1x Show 802.1x content
history Information of history
interfaces Information of interfaces
ip IP information
line TTY line information
log Show the records of login
logging Show the setting of login
mac-address-table Set configuration of the address table
map Map priority
port Characteristics of the port
pvlan Information of private VLAN
queue Information of priority queue
radius-server Radius server information
running-config The system configuration of running
snmp SNMP statistics
spanning-tree Specify spanning-tree
ssh Secure shell
startup-config The system configuration of starting up
system Information of system
tacacs-server Login by tacacs server
users Display information about terminal lines
version System hardware and software status
vlan Switch VLAN Virtual Interface
Console#show
Console#show interfaces ?
counters Information of interfaces counter
status Information of interfaces status
switchport Information of interfaces switchport
Console#
Console#show s?
snmp sntp spanning-tree ssh startup-config
system
