Filter
Top Products
164-122012 Power
POD
400 Page 5 of 42
Important – The Power
Pod
-400 comes calibrated from the factory according to your specifications.
No set up is necessary unless you need to change the specs
1.0 Quick Start Instructions
1ea Power
Pod
-400
1ea AC power cord
1ea 15-pin, Hi Density, D-style connector
1ea 9-pin, D-style connector
1ea user’s manual
When unpacking the Power
Pod
, the package will
contain everything you need.
Connect a “known good” cable to the desired channel
(See next frame for pin-outs)
J-1 Ch1
Transducer Power,
Command and Analog
Signals.
J-2 Ch2
J-3 Ch3
J-4 Ch4
J-5
Analog
out
Transducer Signal, Volts
Only
J-6 RS-232
Serial Com Port
J-7 RS-485
Multi-drop com port
(Daisy Chained)
J-8 Alarms
Open-collector Alarms
J-9 RS-485
Multi-drop com port
(Daisy Chained)
Pin-outs (see section 7)
1) Check power setting switch on the back panel and make
sure it is set appropriately.
2) Ensure the power switch is off, and then connect the power
cord.
CLOSE
P
Pod
ower
HASTINGS
OPEN
OPEN
CLOSE
OPEN
CLOSE
OPEN
CLOSE
1
4
3
2
7
1
4
0
9
3
6
8
2
5
.
1) Press the desired Channel # Key. Press the Auto key.
(For Controllers)
2) Press the desired Channel # Key. Enter desired flow.
Press the enter key.
Turn power switch to on position. If you have just
turned on the mass flow instrument and the
power, some settling is necessary.