Filter
Top Products
164-122012 Power
POD
400 Page 29 of 42
To query the status of the totalizer flag on channel four (4), use the following command.
TF4Cr
The response will be either TF4 0 corresponding to a Boolean ‘FALSE’ indication that the totalizer flag
has not been set, or TF4 1, a Boolean ‘TRUE’, indicating that the total is equal to or beyond the totalizer
set point..
D41Cr command tells channel four (4) to display the TOTAL. It is not necessary that the front panel
read the total for the TOTALIZER to work. The Totalizer works in the background no matter what mode
the display is in.
NOTE: It must be emphasized that, if the total reaches the maximum of the
display (±999999), the unit effectively stops counting.