Sony Music Entertainment DXF-C50WA Video Games User Manual


 
Attaching to the Camera
29
k (attention) indicator (amber)
This indicator lights up when the shutter switch of the
camera is set to ON, or gain is over 3 dB.
Certain models allow you to specify the operating
conditions under which the indicator lights up. For
details, refer to the operating instructions for the camera.
l POWER switch
Turns off the power of the viewfinder and goes into a
power-saving mode when SAVE is selected.
m ASSIGN. (assignable) switches
Can be used to store frequently used functions.
The switch above is the ASSIGN. 1 switch, and the one
below is ASSIGN. 2.
Storing a function is done using “ASSIGN.1” or
“ASSIGN.2” in the FUNCTION menu.
n MENU switch
Displays the menu. Use with the MENU SEL control to
set various functions.
When the menu is not displayed and this switch is pressed
and held for three seconds or more, “VR LOCK” appears.
This locks the BRIGHT, CONTRAST, and PEAKING
controls at their current settings, preventing accidental
operation. To unlock the controls, press this switch for
three seconds or more again so that “VR UNLOCK”
appears.
For details on operations, see “Using the Menu” on page
36.
o MENU SEL (menu selection) control
Turn the control to select a menu item, and then press the
control to confirm the selection. Use with the MENU
switch to set various functions.
When the menu is not displayed, pressing this control
shows the status information of the viewfinder on the
screen.
For details on operations, see “Using the Menu” on page
36.
Attaching to the Camera
1 Slide the bracket fully into the accessory shoe of the
camera until the end stop.
2 Tighten the fixing ring to secure the viewfinder.
3 Connect the connector to the camera’s VF connector.
Clamp the connecting cable with the clamper as
shown in the following figure.
To detach the viewfinder from the camera
Loosen the fixing ring and pull the viewfinder out of the
accessory shoe in the opposite direction.
Accessory
shoe
Stopper
Fixing ring
Bracket
Connecting
cable
Clamper
To the
camera’s VF
connector