Filter
Top Products
13. REPLACING THE FLUORESCENT LAMP AND BUTTONS
When performing the work, be sure to turn power off. Working
with power on can cause an electric shock or short circuit acci-
dent.
The Fluorescent Lamp, when it gets hot, can cause burns. Be
very careful when replacing the Fluorescent Lamp.
To perform work safely and securely, be sure to use a step which is in a
secure and stable condition. Not using a step or using an unstable step can
cause violent falling accidents.
THE FLUORESCENT LAMP
1
Take out the 2 Truss Screws and remove the Plate Holder.
Lower the Billboard Plate and replace the Fluorescent Lamp.
2
START BUTTON AND VIEW CHANGE BUTTON
Use care so as not to damage the wiring connection inside the start button and the view change
button.
Turn power off.
Take out the 4 truss screws.
Disconnect the connector attached to the start button and view change button, and the VR
BUTTON START AND VIEW 1 can be removed.
1
2
3