Filter
Top Products
Select INPUT TEST to have the screen shown below appear and to observe the status of each switch
on the Control Panel. In this mode, Periodically check the status of each switch.
A. INPUT TEST
By pressing each switch, if the display on the right-hand side of
the name of each switch changes from OFF to ON, the SW and
the wiring connections are satisfactory.
Operate CONTROL WHEEL, THRUST LEVER, etc. to check
Volume value display variation.
To check COIN CHUTE 1 & COIN CHUTE 2, open the COIN
CHUTE DOOR and insert a coin(s) in the slot.
“HORN” is for the driver seat and the assisstant driver seat.
Because the same circuit is used for the HORN in both seats, if
the switch and the wiring connection are satisfactory, pressing the
HORN at either side changes the display from OFF to ON.
For the steering wheel, the accelerator, and the brake, operate each
input device and check to see if the value changes in accordance
with operation. Items to be checked :
Each switch (COIN/SERVICE/TEST/START/VIEW
CHANGE/HORN/SHIFT<H L R>)
Each volume (STEERING WHEEL/ACCELERATOR/
BRAKE)
Press the TEST BUTTON and the SERVICE BUTTON simulta-
neously to return to the menu screen.
Select OUTPUT TEST to cause the following screen to appear, and to check the status of each lamp
and motor. In this mode, periodically check each lamp and motor.
Using the SERVICE button, bring the arrow to the desired item
and press the TEST button. The display next to the item changes
from OFF to ON, and the lamp lights up, or the motor functions.
LAMP item : If the lamp lights up, operation is satisfactory.
ROLL LEFT : If the motor moves so as to turn the steering
wheel counterclockwise, operation is
satisfactory.
ROLL RIGHT : If the motor moves so as to turn the steering
wheel clockwise, operation is satisfactory.
Bring the arrow to EXIT and press the TEST BUTTON to return
to the menu screen.
B. OUTPUT TEST
INPUT TEST
COIN CHUTE #1 OFF
COIN CHUTE #2 OFF
SERVICE OFF
TEST OFF
START OFF
VIEW OFF
HORN OFF
SHIFT [L] OFF
SHIFT [H] OFF
SHIFT [R] OFF
HANDLE XXH
ACCEL XXH
BRAKE XXH
OUTPUT TEST
START LAMP OFF
VIEW LAMP OFF
HORN LAMP OFF
ROLL LEFT OFF
ROLL RIGHT OFF
-> EXIT
SELECT WITH SERVICE BUTTON
AND PRESS TEST BUTTON
PRESS TEST AND SERVICE BUTTON TO EXIT