Filter
Top Products
UltraKey Lite Controller Installation and User Guide
Document 800-07422 Rev A 67
08/10
Testing the Hardware
1. Log into the controller.
2. From the System Set: Config menu, press the LCD
up/down arrow keys to scroll to Hardware Test. Press Ent.
3. Press the LCD up/down arrow keys and press Ent to select one or all of the following
test options:
• Key: When you press a key, the key value and its state is displayed on LCD.
• Joystick: When you move the joystick, values which present the PTZ (pan, tilt,
zoom) positions of the joystick are displayed on the LCD.
• Serial port: Confirms that the controller serial port is functioning.
• Slider: When you rotate the touch pad, specific values are displayed on the LCD.
4. Press Alt > Clr to exit from these test menus.
Restoring Defaults
1. Log onto the controller.
2. Use the LCD up/down arrow keys to scroll to Restore
Default in the System Set: Config menu, then press Ent.
A confirmation message Restore Defaults? appears in
the display.
3. Press the LCD up arrow key to select Yes or No.
• Select Yes, then press Ent to restore the defaults.
• Select No, then press Ent to cancel.
Configuration
Hardware test
Configuration
Restore default
Table 5-1 HJC5000 UltraKey Lite Controller Default Settings
Settings Protocol
Network Settings for the Keyboard
IP 192.168.1.9
Net Mask 255.255.255.0
GateWay 192.168.1.1
DNS 192.168.1.1
Default Mode: VideoBlox
Maxpro Mode
Keyboard ID 1
Serial Port Mode RS232
Server Port 26026
Server IP 192.168.1.10
Joystick Speed Normal
Baud Rate 19200 bps