Filter
Top Products
UltraKey Lite Controller Installation and User Guide
Document 800-07422 Rev A 33
08/10
Note For a list of accessories see Shipping Checklist on page 18 and for port
connections see UltraKey Lite Port Connections and Descriptions on page 19.
1. Select the applicable adapter plug and insert it into the AC adapter. Push to click it
into place. See Figure 3-3.
2. Plug the AC adapter into the controller power port and the adapter into a power
source.
3. Connect an RJ45 network cable to the controller serial port.
4. Connect the RJ45 network cable to VideoBloX:
• For backwards compatibility with VideoBloX and VideoBloX Lite CPUs, an RJ45
to DB9 male adapter is required and included with your shipment. See Figure 3-4.
• For VideoBloX NetCPU, the installation is a direct connection with the RJ45
network cable, also included. See Figure 3-5 and Figure 3-6.
Figure 3-3 AC Power Adapter with CEE 7/16 Europlug
Table 3-1 Serial Port COM1 and COM2 Pin Assignments
Serial Port Type Pin Signal
COM1 RS422 1 RX +
2RX –
5GND
7TX –
8TX +
RS485 7 T/R –
8T/R +
Slide plug onto the
adapter and snap
into place