Filter
Top Products
UltraKey Lite Controller Installation and User Guide
Document 800-07422 Rev A 37
08/10
1. Select the applicable adapter plug and insert it into the AC adapter. Push to click it
into place. See Figure 3-3.
2. Plug the AC adapter into the controller power port and the adapter into a power
source.
3. Plug an RJ45 network cable from the network to the controller Ethernet port. Up to 32
controllers can be connected to the network. See Figure 3-7.
4. Connect VideoBloX to the network. Refer to the applicable VideoBloX Installation
Guide for instructions.
Figure 3-7 Ethernet Port Connections to VideoBloX
Step 2: Configure the Controller for VideoBloX Mode
Note The controller factory defaults are VideoBloX mode, Address 1, baud rate
19200 bps. If any other mode has been selected then see Step 2: Configure
the Controller for VideoBloX Mode on page 34 to select VideoBloX mode.
Otherwise skip to the next step.
Table 3-2 RJ45 Ethernet Pin Assignments
Port Pin Signal
RJ45 Ethernet 1 TX +
2TX –
3RX+
6RX –
VideoBloX
Ethernet Port
RJ45 network cables
Ethernet Port
Controller 1
Controller 32
TCP/IP
TCP/IP
Network