Filter
Top Products
UltraKey Lite Controller Installation and User Guide
Document 800-07422 Rev A 55
08/10
Note If the controller cannot connect to the MAXPRO network, then this step
cannot be completed until the connection is established. However, the
MAXPRO settings menu can be configured even if the controller has not
connected to the MAXPRO network; that is, the LCD displays that MAXPRO is
offline.
5. Use the LCD up/down arrow keys to select RS232 or RS422, then press Ent.
6. Use the LCD up/down arrow keys to scroll to an address between 1 and 99 to assign
to the controller, then press Ent to save.
7. Press the down LCD arrow key to scroll to Baud Rate. Press Ent and use the
up/down arrow keys to select a baud rate of 9600 bps or 19200 bps for the controller.
Press Ent to save.
Note 19200 bps is the default baud rate for most MAXPRO systems.
8. Press the down LCD arrow key to scroll to Joystick Speed. Press Ent and use the
up/down arrow keys to select Normal or High. Press Ent to save.
9. Press the down LCD arrow key to scroll to Serial Port
Mode. Press Ent and use the up/down arrow keys to select
RS232 or RS422. Press Ent to save.
Note In the following fields, you are setting the MAXPRO-Net Server IP address and
port number. To set the UltraKey Lite IP address or enter the main
configuration menus, press Alt > Clr.
10. Press the down LCD arrow key to scroll to Server IP. Press
Ent and use the up/down arrow keys or the numeric keys to
enter the Server IP address. Press Ent to save.
11. Press the down LCD arrow key to scroll to Server Port.
Press Ent and use the up/down arrow keys or the numeric
keys to enter the Server Port Address. Press Ent to save.
12. After the MAXPRO settings are complete, press Alt > Clr to
exit the Setup menu.
Step 4: Configure MAXPRO Mode Default Settings While Powering Up
1. While powering up, when the Time Left 3 menu displays,
press Alt > Monitor to set the Maxpro mode.
2. Set the corresponding serial port as:
Maxpro Settings
SerialPortMode:
Maxpro Settings
Server IP:
MaxproServer IP
_59.099.251.132
Maxpro Settings
Server Port:
Time Left 3